2. C C Product. Submersible pump for pumping clean water, surface water and waste water containing solids or long-fibred material. Denomination. Dataplate. rpm. Max 40°C. YSER/Y//V. 26/51A. kWhp. Date: Flygt CS MT. Use our handy online form to submit details on your existing Flygt pump to get a Flygt C Submersible Pumps Range Flygt C LT Submersible.
|Genre:||Health and Food|
|Published (Last):||27 January 2004|
|PDF File Size:||12.9 Mb|
|ePub File Size:||6.92 Mb|
|Price:||Free* [*Free Regsitration Required]|
The starting current in direct-on-line starting can be up to six times higher than the rated current. This applies to the pump equipment, the driver, and any monitoring equipment. It can include such things as impeller trimming, wear part control and replacement, control of zinc-anodes and control of the stator.
Connect the suction line and discharge line.
Flygt 3000 Series / C Submersible Pumps
Lower diffuser Figure These requirements and instructions only apply when the installation is made according to the dimensional drawing. The overload protection Check that the impeller can rotate freely.
The earthing grounding conductors must be correctly connected. Comply with all local codes and regulations. Requirements These general requirements apply for electrical installation: This applies to both ends of the motor cable. Replace the valves, fkygt necessary.
Replace the worn parts. There are signs of wear on the impeller, pump, and casing. If there is a question regarding the intended use of the equipment, please contact an Xylem representative before proceeding. Make sure that the pump is vertical for the T-installation or horizontal for the Zinstallation. Place flyggt pump in a horizontal position.
Flygt Series / C Submersible Pumps
T-installation These items are required: Cause Remedy The motor protection is set too low. Back off the sleeve screws a quarter turn. If the unit is stored more than 6 months, rotate the shaft every other month to prevent the seals from sticking together. Replace the oil plug O-rings. If the insulation is flygh They are connected in series in the stator and activate the alarm at overtemperature.
Due to its design it is best suited for pumps in a vertical position. Dispose of all packing materials in accordance with local regulations.
Mount the suction cover: Grout the anchor bolts in place. The pipes are obstructed.
For more information, see Check the impeller rotation page Note any damaged or missing items on the receipt and freight bill. Flygt Installation, Operation, and Maintenance Manual 47 Troubleshooting Troubleshooting Introduction Follow these guidelines when troubleshooting the pump: Tighten the sleeve screws evenly until 315 wear protection is flush against the impeller. Use an insulation tester. Wash the skin with soap and water for at least one minute.
Flygt Installation, Operation, and Maintenance Manual 11 Product Description Parts 7 6 4 3 2 5 1 12 Positio Part n Description 1 Impeller A wide range of impellers are available for different applications and capacities.